Discuss car audio general Renault CAN Clip troubleshooting

In the use of car audio, car Renault CAN Clip because of the special environment or improper use, easy to make sound failure or damage, according to some of the problems often and fault. Will elimination method is offered. Hope to be able to help you normal use and maintenance car audio.

1, CD part
1) can't into record control program, the main reason is the device for tablet and input not connect (both host not with CD box connection), or loading CD box is not put in place.
2) don't play the specified records, and play other record, the reason is:
² designated disc anomalies, should clean record. Don't clean record down the CD trajectory turn the brush, should to the outside, and track vertical brush, so not damage signal path.
² record in the wrong direction (whether to put back the), normal in the can.
² record have greater damage, should be clear.
3) jump tone.
² record automatically Renault CAN Clip  change the machine contact foreign body, such as the trunk, bulky items.
² record have damage or contamination dirt, etc., such as parking at the same position after still appear ran sound phenomenon, belong to record problem, must clean record.
4) in machine shows that play but no sound, the microprocessor has not normal operation, press the reset button the operation of the normal.
5) to solve will not play designated tracks method is to remove "random broadcast/change machine play" model.
6) in the event of coil winding fault, please immediately shutdown, and eliminate this offer, you shall never again, in order to avoid damage the bald.
Introduced above is car audio basic maintenance and simple troubleshooting methods, if still cannot be used properly, please contact with my center, oneself do not optional drag down machine, in order to avoid expand fault.
2, tape part (tape protection)
1) don't touch the surface of the magnetic tape, because the dust will pollution head.
2) make tape from containing magnetic materials equipment, such as speaker, amplifier etc to prevent prevent prevent erase or destroy tape on the storage of information.
3) do not use tape exposed to Renault CAN Clip  direct sunlight (such as the front windshield) place or in low temperature, the damp environment.
4) relaxation of magnetic tapes, might be haunted tape mechanism. So in the loading before the tape used pencil or similar tool, insert tape rotating shaft of tightening relaxation of the tape.
5) warping tapes or cassete not stick fast label, may in the loading tapes or exclusion cassete caused when the trouble.
6) suggest using tape length below 90 points tape. Because long article tape is very thin, easy to be pulled, cause mechanical failure.
7) tape playback, high attenuation or a track channel acoustic small even silent, this kind of failure for head pollution, clean head can solve.
8) playback tapes throw turn, not on the tail will automatically change the surface, the problem is due to roll too tight, should use normal magnetic tape.
9) tape it doesn't fit or there are tape playback display, but not the sound, this most is due to tape out power on or in the load on the way out to cause, though not in the magnetic tape, operation panel will display tape playback state, this solution is to click on the belt key, first reset and stuck with it.
3, the radio
1) radio signal is very weak, nissan consult 3 even couldn't get a signal. First of all check whether the antenna pull out or extend, joint whether plug firm, antenna whether internal short circuit or open circuit; If the signal is weak, but can listen to, can use manual sorting table or answer required station, or open the remote receiving (DX) mode, then again can be automatic sorting table.
2) if the receiving station less frequency display only dual singular or only when please check system is choosing the right.
3) if the choice of radio stations, ignition switch in "OFF" store content disappear, please check the power cord (BATT line), whether to have electric (should be semester electric)